C2044 BMW Fault Code

Description:

BMW Mass Air Flow (MAF) Sensor Intermittent The MAF sensor circuit is monitored by the PCM for sudden voltage (or air flow) input change through the comprehensive component monitor (CCM).

If during the last 40 warm-up cycles in key ON engine running the PCM detects a voltage (or air flow) change beyond the minimum or maximum calibrated limit, a continuous memory diagnostic trouble code (DTC) is stored.

C2044 Code Symptoms :

If your C2044 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C2044 and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.

Diagnosis And Repairing C2044

C2044 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix C2044 code ?

• Failures of clutch motion/travel sensors.
• Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
• Fuel tank leaking
• Open or short in the CMP sensor circuits

As long as the throttle plate remains closed, the idling speed and quality is controlled by the PCM via the idle control valve, and as can be seen from the above it should be clear that idle control on a gasoline engine is a complex affair.

For instance, if the engine is started in sub-zero temperatures, the PCM will command the idling control valve to allow less air to enter the engine to enrich the air/fuel mixture to create a condition which is roughly analogous to how chokes worked on carburetted engines to control idling in cold weather.